The left fender wasn't too bad, with only about three areas needing replaced due to stress cracking and this large area that had some deep creases and was badly dented. I had another “student”, Johnny Pfalzgraf here for a week, so I put him to work on the front fenders.

The right fender required quite a bit more work.

Here's the car ready to leave the shop. The owner showed up a few hours earlier than expected, otherwise, it would have been cleaned up and the bare metal sanded out nice. He was happy with it regardless.

We built the steel decklid and tail panel assembly shown in this picture. Extensive work was done to the quarter panels too. The rear fenders and rocker panels are also items we built for the car.

The front center section is another item we built for this car.

This is the center section on display at the National Hot Rod Reunion.